Daedong KIOTI EX40 - Using Tractor after Storage; Usage and Disposal

8
-
PB
8
-
4
STORAGE AND DISPOSALEX35(C)/EX40(C)/EX45(C)/EX50(C)
1. Check the tire air pressure and
inatethetiresiftheyarelow.
2. Install a fully charged battery.
3. Check the fan belt tension.
4.Checkalluidlevels.(Engineoil,
transmission/hydraulic oil, engine
coolant and any attached imple-
ments.)
5. Remove grease from the ex-
posed cylinder rod.
6. Apply grease to the lubrication
points.
7. Remove the cover from the ex-
haust pipe.
8. Depress the clutch pedal and
disengage the latch hook.
9. Get onto the tractor and start the
engine.
10. Check if the instrument pan
-
el and all parts operate correct-
ly while running the engine for a
few minutes.
11. Drive the tractor outside and
check if it is operating proper-

If the battery is not to be re-
moved, disconnect its nega-
tive terminal at least. The wir-
ing can be gnawed by rodents,
leading to a re.
USAGE AND DISPOSAL
In order to protect the environment,
use and dispose of the tractor keep-
ing the following in mind:
1. When changing the oil or coolant
by yourself, be careful not to spill it
and dispose used oil and coolant
properly according to the applica-
ble regulations.
2. Never leave or discard the expired
tractor or implement, but contact
your local KIOTI Dealer to dispose
it according to the regulations.
3. Avoid working under high load as
it can cause excessive exhaust
gas, which is harmful to the envi-
ronment.
USING TRACTOR AFTER STORAGE
ly. Park the tractor outside and
idle engine for at least 5 minutes.
Stop the engine and visually in-
spect the tractor. Check if there
is leakage.
12. Start the engine, release the
parking brake, and check the
brake condition while driving for-
ward. Adjust the brake pedals if
necessary.
13. Stop the engine and check for
leakage. Repair any part as re-
quired.
CAUTION
M47-EU-08.indd 4 2012-03-14 오후 7:20:45