Daedong KIOTI EX40 - Exterior Hydraulic Control System

5
-
27
5
-
26
OPERATIONEX35(C)/EX40(C)/EX45(C)/EX50(C)
5
-
27
5
-
26
OPERATIONEX35(C)/EX40(C)/EX45(C)/EX50(C)

If the lifting arm is properly op-
erated but abnormal noise is
still heard, the hydraulic sys-
tem may be malfunctioning. In
this case, let the engine idle
for an 10 to 15 minutes addi-
tionallly and then try to start
the engine again. If the prob-
lem is still present, contact
your local KIOTI Dealer.
7. However, if the draft control lever is
pushed forward to its end, the low-
est position of the lifting arm can be
lowered a little. On the other hand,
if the lever is pulled back to its end,
the highest position of the lifting
arm can be raised a little.
CAUTION

The implement may shake up
and down as the draft sensor
is under impact when the trac-
tor is passing over irregular
ground with the middle or low-
est top link hole selected. In
this case, put the draft control
lever to the “Deep” position
to decrease the sensitivity of
the draft function or select the
highest top link hole.

If the tractor has been stored
for a long period of time or
the transmission fluid is just
changed, abnormal noise may
be heard and the hydraulic lift-
ing arm may be inoperable tem-
porarily. In this case, let the en-
gine idle for 3 to 4 minutes.
(1) Double Acting Valve Lever
(A) Port A (Single Acting)
(B) Port B
H11O528a
EXTERIOR HYDRAULIC CON-
TROL SYSTEM
DOUBLE ACTING VALVE LEVER
CAUTION
M47-EU-05.indd 26 2012-03-14 오후 7:17:52