Daedong KIOTI EX40 - Page 149

5
-
25
5
-
24
OPERATIONEX35(C)/EX40(C)/EX45(C)/EX50(C)
5
5
-
25
5
-
24
OPERATIONEX35(C)/EX40(C)/EX45(C)/EX50(C)
DRAFT CONTROL (IF EQUIPPED)
(1) Draft Control Lever
(A) Lowering
H11O527a
1. The draft control function is used
to prevent the wheels from rotat-
ing idle and the engine from stop-
ping due to excessive draft load
when the tractor is used for work
which requires a lot of draft, such
as plowing.
H11O581a
(1) Top Link
ing depth while the draft control le-
ver is set to the “Shallow” position,
the plowing depth is maintained
as shallow because the reaction
force is transferred to the internal
system via the top link and the lift-
ing arm is automatically lifted.
4. To keep the plowing depth deep,
put the draft control lever to the
front (deep) position.
5. The position of the draft control le-
ver should be different based on
the condition of soil to keep the
plowing depth constant.
When working on a new field, it
is recommended to put the draft
control lever to the proper position
for the desired plowing depth and
lock the lever with the lock bolt.
6. When using an implement which
requires no draft function, such as
a rotary tiller and mower, use the
highest hole on the top link and
put the draft control lever in any
position.
2. The draft function is activated
when the lowest or middle hole on
the top link of the 3-point hitch is
used. The lowest hole is for sensi-
tive draft control.
3. To keep the plowing depth shal-
low, put the draft control lever to
the rear (shallow) position.
The plowing depth tends to be-
come deeper naturally by outer
condi-tions. When the load increas-
es by the increase of the plow-
M47-EU-05.indd 25 2012-03-14 오후 7:17:50