Daedong KIOTI EX40 - Page 68

4
-
13
4
-
12
DESCRIPTION OF OPERATING SYSTEMEX35(C)/EX40(C)/EX45(C)/EX50(C)
4
-
13
4
-
12
DESCRIPTION OF OPERATING SYSTEMEX35(C)/EX40(C)/EX45(C)/EX50(C)
This switch is used to switch the PTO
between automatic and manual op-
eration.
1. PTO Automatic
When the PTO selection switch is
put to the automatic operation po-
sition, the PTO is automatically
disengaged after the hydraulic lift-
ing arm (or implement) is lifted by
the position control lever.
PTO AUTO/MANUAL SELECTION
SWITCH, PTO ON/OFF SWITCH
(1) PTO Auto/Manual Selection Switch
(2) PTO ON/OFF Switch (A) Automatic
(B) Manual (C) On (D) Off
To avoid personal injury and ac-
cident:

Before disassembling or clean-
ing the PTO system, make
sure that the PTO switch is in
the “OFF” position, the engine
is stopped, and all parts are
stopped.

Always keep the PTO driving
part clean. Also, check that the
PTO cover is open.

Disengage the PTO and the
connecting shaft while driving
on a road.

Be c a r e ful n o t t o get y o ur
hand, foot, cloth, or hair into
any driving part while the PTO
is in operation. You can be se-
verely injured.

M a k e s u r e t h a t n o o n e i s
around the tractor and imple-
ment while the PTO is in oper-
ation.
CAUTION
H11O415A
Except EU
The PTO switch is used to supply
power from the tractor to the imple-
ment.
Make sure to put this switch into the
“OFF” position before starting the en-
gine. Otherwise, the engine cannot
be started.
The rear PTO rotates at 540 rpm (1st)
when the engine speed is approx.
2,500 rpm. The mid PTO rotates at
2,000 rpm when the engine speed is
approx. 2,500 rpm.
M47-EU-04.indd 12 2012-04-06 오후 3:30:35