Check the tire pressure using a tire gauge.
Check tire pressure when the tires are
cool.
When removing the pillion seat and open
the battery box cover, you can find the
battery. If the battery terminal is polluted
or in-rust, separate battery and clean it.
●
Battery terminal in rust with white
powder should be cleaned with warm
water.
●
In case of serious rust of battery
terminal, disassemble the battery cord
and grind it with wire brush or
sandpaper.
35
TIRE PRESSURE INSPECTION
●
If air pressure is inadequate or it there
are cracks, damage or abnormal wear
on tires, it may cause trembling
steering wheel and flat tire.
SIZE
TIRE
PRESSURE
(kgf/ )
DRIVER
ONLY
FR.
1.75
120/70-13
130/60-13
2.00
2.25
2.25
RR.
RR.
FR.
FRONT
REAR
DRIVER &
PASSENGER
BATTERY INSPECTION
●
Turn the ignition switch OFF before
disconnecting the terminal from the battery.
Disconnect the negative(-) terminal lead from
the battery first. When connecting, connect
the positive(+) terminal lead first. If you work
in reverse order, short circuit will occur
resulting in fire.
●
Make sure that terminals do not contact with
other adjacent parts when handling (+), (-)
terminals. Contact with other parts may cause
spark resulting in electrical equipment
malfunction, fire and electric shock.
●
Do not apply excessive impact. When
handling the battery, stay away from
flammable materials.
●
If the electrolyte contact with terminal, it will
be corroded earlier.
●
The battery is shield type, so do not
disassemble the pouring plug.
●
When not using vehicle during a long time,
take off the battery from the vehicle to keep
from self-discharge and electric discharge.
Put the battery in a well ventilated place after
charging fully. In case it isn’t available to
take battery off from the vehicle, disconnect
(-) terminal.
To Next Page
Loading...
Need help?
General
