CLEANING
40
●
Erect main stand and place vehicle in
up
right position on level ground.
●
Check the spring for damage or loss of
tension and the side stand assembly for
freedom of movement.
●
Check the side stand ignition cut-off
system;
① Put the side stand up.
② Start the engine.
③ Lower the side stand. The engine
should stop as you put the side stand
down.
●
If the side stand system does not
operate as described, inspect it in the
closest authorized repair center.
●
Make sure to stop the engine prior to
car washing.
●
Be careful not to allow water to enter
the muffler during the washing.Water
inside the muffler may cause an
improper engine starting or rust
occurrence.
●
Do not let water get inside the braking
system during the washing, as water
inside the brake system may weaken
the braking power. Upon completion of
washing, select a safe place where
there is no traffic obstruction, and start
the vehicle.
Lightly apply the brake while driving at
a slow speed and check the braking
power. If the braking power has been
weak-ened, apply brake lightly while
driving at a slow speed to dry up the
brake system.
●
Take precautions when waxing the
vehicle. Excessive polish of the painted
section and/or the resin part with
compound wax might damage the
painted section causing discoloration of
the affected area.
SIDE STAND
SPRING
SIDE STAND
MAIN STAND
SIDE STAND INSPECTION