4-36 Inspection, Maintenance and Adjustment K1000896E Operation and Maintenance Manual
4. Fill engine with correct oil through oil fill
port (2, Figure 64).
5. Start engine and check engine oil pressure
light.
6. Shut down engine. Look for signs of leaks
at filter. Recheck oil level using dipstick (1,
Figure 64).
REPLACE FUEL FILTER
1. Locate fuel filter inside engine
compartment.
2. Position a small container under fuel filter.
Drain filter by opening drain valve on
bottom of filter (Figure 65 and Figure 66).
NOTE: Dispose of drained fluids
according to local regulations.
3. Unscrew fuel filter from head assembly.
Discard fuel filter.
4. After cleaning filter head, install new fuel
filter. Screw filter on head until gasket
contacts head, turn filter 1/3-1/2 turn more.
NOTE: Coat fuel filter gasket with fuel.
NOTE: Fill fuel filter with clean fuel.
This will help reduce fuel system priming.
5. Start engine. After engine has run for a
couple of minutes, shut down engine and
look for leaks.
If engine does not start, fuel system may
need priming. Prime fuel system using the
following procedure:
A. Loosen plug on top of fuel filter head.
B. Unscrew and pump the hand
operated primer pump near fuel
injection pump. Pump primer until
fuel is present at plug hole in fuel
filter head.
WARNING!
Exchange filter after waiting for engine to cool. Be careful of fire hazards. Do not smoke.
1
2
BAO0040L
Figure 64 (S/N 4001 and Up)
Figure 65 (S/N 3001 thru 4000)
Figure 66 (S/N 4001 and Up)
To Next Page
Loading...
