K1000896E Operation and Maintenance Manual Inspection, Maintenance and Adjustment 4-37
C. Tighten plug in fuel filter head.
D. Continue to pump primer pump until a strong resistance is felt. Screw primer pump knob back
into housing.
E. Start engine and look for signs of leaks.
HYDRAULIC FULL FLOW FILTER REPLACEMENT
NOTE: Replace hydraulic full flow filter after first 50 hours of operation and every 500 Hours
thereafter.
WARNING!
The hydraulic oil will be hot after normal machine operation. Allow system to cool before
attempting to service any of the hydraulic components.
The hydraulic tank is pressurized. Loosen hydraulic oil fill cap slightly to allow pressurized air to
vent. After pressure has been released, it is safe to remove either the fill cap or service covers or
drain water from the tank.
IMPORTANT
Make sure to clean any dirt or water from top of the hydraulic tank, especially around fill port and
filter ports.
To Next Page
Loading...
