19
2-1. Wash Program
1) Wash Programs
1 The default washing times and water levels apply for all the programs without sensing the load.
2) Wash Times
* Washing time after the water temperature reaches the target level.
1 The washing time consists of heating cycle and post-heating main wash cycle. The time displayed for
heating cycle elapses immediately on completion of heating cycle or remains unchanged until the heating
cycle is over.
2 The heating cycle is complete when the water temperature reaches the target level.
- If the water temperature doesn't reach the target level after the heating cycle under the Baby Care, Cotton
40, Cotton 60, Intensive 40, Intensive 60, program, the time on display stops declining and an additional
heating cycle applies for 10 minutes. If the water temperature doesn't reach the target level after the
additional cycle, the heating cycle is suspended and the main wash cycle starts.
3 The water heater does not resume its operation after it is turned off when the water temperature reaches the
target level.
1. MINI 1.0: D-CV701*, WFWM11*
2. MINI 1.5: ODW30-999B, ODW30-999G, DWM30-999PG, WFWM12*
2. Program Functions
Category
Program
Water level
Time of water
supply
Heating time Wash time Total wash time
Normal Default 2min - 8min 10min
Delicate Default 2min - 11min 13min
Baby Care Default 2min 47min 15min 64min
Night Time Default 2min - 12min 14min
QUICK15 Default 2min - 4min 6min
INTENSIVE Default 2min - 10min 12min
INTENSIVE40 Default 2min 15min 25min 42min
INTENSIVE60 Default 2min 60(NO Heating)+20min 228min 310min
Category
Program
Water level
Time of water
supply
Wash 1 time Heating time Wash 3 time
Total wash
time
Normal Default 2min 4min - 4min 10min
Delicate Default 2min 5min - 6min 13min
Baby Care Default 2min 2min 47min 13min 64min
Speed up Default 2min 4min - 0min 6min
Tub Clean Default 2min 5min - 5min 12min
To Next Page
Loading...
Need help?
General