To Next Page

To Previous Page

2-2. Rinse Cycle

1) Drainage

1 If the water is 55°C or hotter, cold water is added to lower the water temperature. When the water

temperature decreases to 50°C or lower, water drainage resumes.

2 After the water drainage starts, the drain pump continues to work.

3 If the water level lowers to the reset level within 60 seconds, the waiting time of 20 seconds applies.

Otherwise, the waiting time of 40 seconds applies.

2) Intermediate Spin

1 Intermediate spin is run at the pre-determined speed for each program.

3) Water Supply

1 Only cold water is supplied to the rinse cycle.

2 Fabric softener is added to the final rinse cycle.

4) Resupply of Water

1 The water level is measured a minute after the rinse cycle starts to determine whether water needs to be

added to raise the water level to the preset level.

2-3.Spin Cycle

1) Drainage

1 It is equivalent to the drainage cycle for rinsing.

2-3.Spin Cycle

1) Termination of Door Lock

1 After the electric signal to door lock is cut off, the door is shaken horizontally until it becomes mechanically

openable.

MINI 1.0: D-CV701*, WFWM11*

MINI 1.5: ODW30-999B, ODW30-999G, DWM30-999PG, WFWM12*

Daewoo MINI Series User Manual

Questions and Answers: