User’s Manual
57
TCP/IP
Configure the settings for network parameters.
Table 5-4 Network parameters
IP Version
In the
list, you can select
or
supported for access.
MAC Address Displays the MAC address of the Device.
DHCP
Enable the DHCP function. The IP address, subnet mask and default
gateway are not available for configuration once DHCP is enabled.
If DHCP is effective, the obtained information will display in the
box,
box and
box. If not, all
values show 0.0.0.0.
If you want manually configure the IP information, disable the DHCP
function first.
If PPPoE connection is successful, the IP address, subnet mask,
default gateway, and DHCP are not available for configuration.
IP Address
Enter the IP address and configure the corresponding subnet mask and
default gateway.
IP address and default gateway must be in the same network segment.
Subnet Mask
Default Gateway
DNS DHCP Enable the DHCP function to get the DNS address from router.
Preferred DNS In the
box, enter the IP address of DNS.
Alternate DNS In the
box, enter the IP address of alternate DNS.
MTU
In the
box, enter a value for network card. The value ranges from
1280 byte through 1500 byte. The default is 1500.
The suggested MTU values are as below.
1500: The biggest value of Ethernet information package. This value
is typically selected if there is no PPPoE or VPN connection, and it is
To Next Page
Loading...
Need help?
General
