Dahua DB11 - Set PIR Motion Detection Zone

24
Figure 5-6
Select “Ring Setup”.
The system displays ring list, as shown in Figure 5-7. A, B and C represent ring A, ring
B and ring C.
Figure 5-7
Select a ring, and press [Save] to complete adding.
5.1.5 Set PIR Motion Detection Zone
After setting PIR motion detection zone, a motion detection alarm will be sent if an object
moves in the zone.
Select “Me> My Device > Device Name > PIR Zone”.
The system displays zone setup interface, as shown in Figure 5-8.
Figure 5-8
Set PIR motion detection zone and distance.
 Press zone block to enable or disable PIR motion detection of this zone.
 Slide the dot in the left; adjust far/near detection distance of the zone.