Local Configurations 49
By default, the user is admin.
In the Password box, enter the password for admin.
The new password can be set from 8 characters through 32
characters and contains at least two types from number, letter and
special characters (excluding"'", """, ";", ":" and "&").
In the Prompt Question box, enter the information that can remind
you of the password.
On the login interface, click , the prompt will display to help you
find back the password.
Click to turn off the Device.
Table 5-1
Click Next. Step 7
The Unlock Pattern interface is displayed. See Figure 5-5.
Figure 5-5
Draw an unlock pattern. Step 8
After the setting is completed, the Password Protection interface is displayed. See
Figure 5-6.
The pattern that you want to set must cross at least four points.
If you do not want to configure the unlock pattern, click Skip.
Once you have configured the unlock pattern, the system will require the unlock
pattern as the default login method. If you skip this setting, enter the password for
login.
To Next Page
Loading...
Need help?
General