Installation and Configuration 9
After intercoms need initialization have been initialized, click Next on Figure 2-9, the
configuration interface will be displayed. See Figure 2-11.
Configuration interface
Tap Edit behind each device to do configurations.
Configure main VTH and Sub-VTH. There must be only one main VTH and one or
more sub VTHs.
If there are no sub VTHs, then you do not need to do sub VTH configurations.
1) Select an indoor monitor (VTH).
The VTH Config interface is displayed. See Figure 2-12.
Indoor Monitor (VTH) config
2) Select Main or Sub.
3) Enter local IP, Network, and gateway.
4) Tap OK.
To Next Page
Loading...
Need help?
General
