Installation and Configuration 8
Tap Cancel, you need to configure parameters for the indoor monitor (VTH) according
to your needs.
All intercoms displayed
Select an uninitialized device.
The Device Init interface is displayed. See Figure 2-10.
Initialization of all intercoms must be done on the indoor monitor (VTH); otherwise
the quick configuration might fail.
If no device is uninitialized, tap Next to go to the configuration interface. See
Figure 2-11.
Device Init
Enter password, confirm password, and email for the device you are to initialize.
Tap OK.
The intercom list interface is displayed again. See Figure 2-11.
To Next Page
Loading...
