35
Save video scheme Figure 4-12
Configure the current layout again, and repeat Step 2 to add more schemes. Step 3
Click Clear Scheme to clear all schemes.
Set tour time interval. Default tour time interval is 30 seconds. Step 4
Click at the top right corner of each scheme to add the scheme to tour queue. Step 5
turns into a number, meaning its sequence in tour queue.
Double-click Control ID and scheme name, and you can change them.
Set tour sequence. Figure 4-13
Click Start. Step 6
Scheme tour starts, and tour information is displayed at the bottom right corner of the
interface.
Tour information Figure 4-14
Click Stop to stop tour.
During scheme tour, video wall interface cannot be operated.
Click Clear to clear the whole scheme tour plan.
Control ID distinguishes different schemes when central control device issues
commands.
To Next Page
Loading...