72
MAC conflict Figure 4-70
Select Enable to enable the alarm function. Step 2
Configure the parameters. Step 3
Table 4-16 Abnormal parameters description
Parameter Description
Alarm Output
Connect alarm output port with alarm devices (such as light and siren
etc.). In case of alarm, the system will send alarm information to alarm
devices.
Click Setup to select slot.
Output Delay
After the alarm is stopped, the alarm output is delayed for some time,
ranging from 0 seconds through 300 seconds.
Buzzer The system activates a buzzer alarm when an alarm event occurs.
Log The log records alarm information when an alarm event occurs.
Click Save. Step 4
4.5.4 Signal Management
You can manage network signal, local signal and signal group.
4.5.4.1 Network Signal
You can add devices in the network, preview and display network signal on the video wall, and also
control the remote device.
The device shall have a decoding card, so network signal can be decoded and displayed on the video
wall.
Select Setup > Signal Management > Network Signal. The Network Signal interface is displayed.
To Next Page
Loading...