65
Select Setup > System Config > Storage Path. Step 1
The Storage Path interface is displayed.
Storage path Figure 4-61
Click Browse to select the storage path for snapshots and records respectively. Step 2
Click OK. Step 3
Click Default to restore default path. Default storage path of monitor snapshot and monitor
record is C:\PictureDownload and C:\RecordDownload respectively.
4.5.2 Network
4.5.2.1 TCP/IP
Set device IP address, DNS server information and other information according to network planning.
Before configuring network parameters, make sure that the device is connected to the network
properly.
If there is no routing device in the network, distribute IP address in the same network segment.
If there is a routing device in the network, you only need to configure gateway and subnet
mask.
Select Setup > Network > TCP/IP. Step 1
The TCP/IP interface is displayed.
TCP/IP Figure 4-62
To Next Page
Loading...