51
PTZ Control Figure 4-39
Table 4-7 PTZ parameters description
Parameter Description
Scan
Click Setup, turn the camera with direction buttons, and click Set Left
Border and Set Right Border to set left and right borders of PTZ scan.
Click Start, and PTZ starts to scan. Click Stop, and PTZ stops scanning.
Preset
Determine a point, and then click Add to add a preset point.
In the input box, enter the preset value, and then click View; the camera
moves to the location of preset point.
Point Tour
Enter preset point number, and then click Add to add this preset point
after the last preset point of this tour path.
In the input box, enter tour path, and click Start to start tour. Click Stop to
stop tour.
Pattern
Click Add, and you can configure a new pattern path with Start Record
and Stop Record.
Enter the pattern value, and then click Start to start pattern. Click Stop to
stop the pattern.
Pan
Click Start, and PTZ starts to pan. Click Stop, and PTZ stops panning.
Lamp Wiper
Click Enable to enable the lamp and wiper, and click Disable to disable the
lamp and wiper.
To Next Page
Loading...