47
Card management
Click Issue Card.
Swipe the card on the corresponding VTO.
The card information will be added to the VTH. Assign unlock permission by selecting
Lock 1 and Lock 2 as needed.
Click Confirm.
Click Delete to delete the card information.
4.6.3 Alarm Setting
Set wire zone, wireless zone and alarm output.
Zones can be set under disarm mode.
4.6.3.1 Wire Zone
Set zone type, NO/NC, alarm status and delay. It supports to set 8 zones at most.
Tap Setting.
Enter login password and tap OK.
Default login password is 123456. Please refer to "4.6.6.3 Password Setting" for details.
Select Alarm > Wire Zone.
To Next Page
Loading...
