User’s Manual
156
Click Apply to save the settings.
5.10.3.2 Configuring White Light
When the motion detection alarm is activated, the system links the camera to generate white light
alarm.
To use this function, connect at least one white light camera to your Device.
Select Main Menu > ALARM > Alarm-out Port > White Light.
White light
Configure the settings for the white light parameters.
Table 5-28 White light parameters
Channel
In the
list, select a channel that is connected to a white light
camera.
Delay
Set a length of time for the Device to delay turning off alarm after the
alarm is cancelled. The value ranges from 5 seconds to 30 seconds, and
the default value is 5 seconds.
Mode Set the alarm mode of white light to be
or
.
Flicker Frequency
When setting the alarm mode of white light to be
, you can select
the flash frequency from
,
, and
.
Click Apply to complete the settings.
To Next Page
Loading...
Need help?
General