User’s Manual
168
Show Message
Select the
check box to enable a pop-up message in your
local host PC.
Send Email
Select the
check box to enable the system to send an email
notification when an alarm event occurs.
To use this function, make sure the email function is enabled in
Main
Menu > NETWORK > Email
.
Buzzer Select the check box to activate a buzzer noise at the Device.
Log Select the check box to enable the Device to record a local alarm log.
Post Record
Continue to record for some time after the alarm is ended. The value ranges
from 10 seconds to 300 seconds.
Alarm Tone
Select to enable audio broadcast/alarm tones in response to a network
alarm event.
Click Apply to complete the settings.
5.10.6 Configuring Disarming
You can disarm all alarm linkage actions as needed.
Select Main Menu > ALARM > Disarming.
Click to enable disarming.
Disarming
Select alarm linkage actions to disarm.
All alarm linkage actions will be disarmed when you select All.
Click Apply.
To Next Page
Loading...
Need help?
General