User’s Manual
274
Username,
Password
Enter the username and password for authentication.
Select the Enable check box.
Click Dial to start connecting.
After the connection is established, the result is displayed in the Wireless Network area.
Wireless network
Click Apply to complete the settings.
Supported 3G/4G Modules by the Device
China Mobile 3G/4G: ZTE MF832S
China Mobile 4G: ZTE MF832S
China Unicom 3G: ZTE MF667S
China Telecom 4G: ZTE AC2736
If the Device is connected to China Telecom 3G/4G network, you can log into the Device with the
public IP address through the PC of public internet (The HTTP port is not configured as 80). If the
Device is connected to China Unicom or China Mobile 3G network, which are defined as private
network, therefore you cannot log into the Device through PC that is connected to public internet.
The Ethernet card names that are displayed on the 3G/4G interface are not constant, and they
could be ppp5, ppp6, ppp7 or ppp8 and are different depending on the USB2.0 port on the Device
that is connected to the 3G module.
If you dial to connect to 3G/4G network, you have to keep trying till succeeded. The default
gateway could be switched depending on the priority of Ethernet cards.
To Next Page
Loading...
