25
Figure 3-13 Schedule Time
Please refer to the following sheet for detailed information.
Parameter Function
Channel
Please select a channel first.
Pre-record Please input pre-record value here.
System can record the three to five seconds video before activating
the record operation into the file. (Depends on data size).
Storage
Right now the system does not support this function.
Setup
z
In Figure 3-11, click set button, you can go to the corresponding
setup interface.
z
Please set schedule period and then select corresponding record
or snapshot type: motion detection/snapshot, and alarm/snapshot.
Right now system does not support schedule/snapshot function,
z
Please select date (Current setup applies to current day by default.
You can draw a circle before the week to apply the setup to the
whole week.)
z
After complete setup, please go back to Figure 3-11 and then click
save to save current time period setup.
Save You can click save button after you complete setup for one channel,
or you can complete the whole setups and then click save button.
Refresh Click this button to get device latest configuration information.
3.2.4 RS232
The RS232 interface is shown as in Figure 3-14.
To Next Page
Loading...
