42
Parameter Function
Hot swap This function allows you to hot swap the disk when the device is
working. This function will not result in disk malfunction.
Execute Click this button to save disk current status.
3.3.2 Alarm I/O
Here you can search alarm output status. See Figure 3-30.
Figure 3-30 Alarm I/O Configuration
Please refer to the following sheet for detailed information.
Parameter Function
Alarm output There is only one output channel. Please click the button 1.
Trigger Enable/disable alarm output device.
Refresh
Search alarm output status.
3.3.3 Record
Record control interface is shown as in Figure 3-31.
Please note current IPC series product does not support this function.
To Next Page
Loading...
