47
Please refer to the following sheet for detailed information.
Parameter Function
Event
Type
z
The abnormal events include: no disk, no space, disk error, net error,
offline, IP conflict.
z
Threshold: You can set the minimum percentage value here. The
device can alarm when capacity is not sufficient.
z
You need to draw a circle to enable this function.
Normal
Out
The corresponding alarm output channel when alarm occurs, There is
one channel.
Record
channel
System auto activates channel to record once alarm occurs (For offline
type only. See Figure 3-36. ). Please note you need to go to chapter
3.3.3 record to set current period as auto record.
Record
latch
System can delay the record for specified time after alarm ended. The
value ranges from 10s to 300s.
Latch The alarm output can delay for the specified time after alarm stops. The
value ranges from 10s to 300s.
Send
email
If you enable this function, system can send out email to alarm the
specified user.
This function is invalid when network is offline or IP conflict occurs.
3.4 Additional Function
3.4.1 Configure
Here you can set camera property parameter. See Figure 3-37.
The following interface may vary due to different IPC series.
To Next Page
Loading...
Need help?
General
