29
Parameter Function
Multiple
cast
group
z
Set MULCAST address and port.
z
Enable MULCAST function.
z
Current series IPC does not support this function right now.
Remote
Host
PPPOE
z
Input the PPPoE user name and password you get from the IPS (internet
service provider) and enable PPPoE function. Please save current setup and
then reboot the device to get the setup activated.
z
Device connects to the internet via PPPoE after reboot. You can get the IP
address in the WAN from the IP address column.
Email
The email interface is shown as in Figure 3-17.
Figure 3-17 Email
Please refer to the following sheet for detailed information.
Parameter Function
SMTP Server
Input server address and then enable this function.
Port Default value is 25. You can modify it if necessary.
User Name
The sender email account user name.
Password
The sender email account password.
Sender
Sender email address.
To Next Page
Loading...
