6
3 Preparation and Commissioning
Carry out commissioning to ensure that the device can realize basic network access, call and
monitoring functions.
Preparation
Before commissioning:
Power on the device only after there is no short or open circuit.
Plan IP addresses and numbers (works as phone numbers) for every VTO and VTH.
Confirm the position of the SIP server.
The device must be used with a VTO that is the SIP server. This section takes a unit VTO as an
example. See corresponding user’s manuals for other VTO types.
Log in to the web interface of every VTO and VTH and configure all relevant information.
3.1.1 VTO Settings
3.1.1.1 Initialization
For first-time use, you must initialize the device.
Make sure that the IP addresses of the PC and VTO are in the same network segment. The default IP
address of VTO is 192.168.1.108.
Power on the VTO.
Go to the default IP address of VTO in the browser.
Device initialization
Enter the password and confirm it, and then click Next.
To Next Page
Loading...
Need help?
General
