User's Manual
145
Figure 4-45
Step 9 Set camera IP address.
●
Check
DHCP
, there is no need to input IP address, subnet mask, and default gateway.
Device automatically allocates the IP address to the camera.
●
Check
Static
, and then input IP address, subnet mask, default gateway and incremental
value.
●
If it is to change several devices IP addresses at the same time, input incremental value.
Device can add the fourth address of the IP address one by one to automatically
allocate the IP addresses.
●
If there is IP conflict when changing static IP address, device pops up IP conflict
dialogue box. If batch change IP address, device automatically skips the conflicted IP
and begin the allocation according to the incremental value.
Step 10 Click
Next
.
The
Device Initialization
interface is displayed. See Figure 4-46.
To Next Page
Loading...
Need help?
General
