User's Manual
240
Table 4-36
Parameter Description
Name Customize the rule name.
Direction
Set the tripwire direction, including A
→
B, B
→
A and A
↔
B.
Filter target
Click to filter the target. Check the blue wireframe and adjust the
size of the area with the mouse.
Each rule can set 2 target filters (maximum size and minimum size), that
is, when the passing target is smaller than the minimum target or larger
than the maximum target, no alarm will be generated. The maximum
size should not be smaller than the minimum size.
AI Recognition
Select AI recognition and the system displays alarm target. The default
selection is person and motor vehicle and system automatically
identifies the person and motor vehicle appeared within the monitoring
range.
When you select IVS of AI by camera, the connected channel shall
support tripwire function.
3) Press and hold down the left button on the monitor screen to draw the line. The line
can be a straight line or a curve.
4) Click
OK
to complete the rule setting.
Step 3 Click .
The
Parameters
interface is displayed. See Figure 4-140.
Figure 4-140
Step 4 Configure the parameters.
To Next Page
Loading...
Need help?
General
