Interface Operation 49
Figure 6-9
Press [Add].
Press wireless code button of wireless device. Please refer to wireless device user’s
manual for details.
After successful coding, display area info.
Press corresponding positions to set alarm status, enter delay and exit delay. Please
refer to Table 6-2 for details.
Press [Edit] to select a zone and press [Delete] to delete the selected area.
6.2.3.3 Alarm Output
After enabling alarm output, when other devices call this VTH, the alarm output device will
output alarm info.
Press [Setting].
The system pops up “Password” prompt box.
Input login password and press [OK].
Default login password is 123456. Please refer to “6.2.6.3 Password Setting” for
details.
Select “Alarm > Output”.
The system displays “Output” interface, as shown in Figure 6-10.
To Next Page
Loading...
