Dahua VTH5221DW-C - Mode

Parameter
Note
Zone
Set detector zone no.
Type
According to each zone detector type, select zone type, including IR,
gas, smoke sensor and etc.
NO/NC
Set detector NO or NC.
Alarm
Status
Instant alarm：once prompt tone stops, it enters arming.
Delay alarm：it enters arming when delay time ends.
Bypass：this zone is shielded during current arming. When disarm, it
restore non-bypass status.
Remote：This zone is shielded during arming and disarming.
Enter
Delay
After disarming is set, it delay by this set time before disarming.
Exit Delay
After arming is set, it delay by this set time before alarming.
Chart 5-1
5.2.4 Mode
Go to Setting/Mode, set switch status of each zone under each mode, including stay, away,
sleep and custom. See Figure 5-6.
Note:
You can set zone switch status for each mode in disarming status only.
Figure 5-6