Warning:
Before config, please make sure VTO is plugged to power and is in the same segment with
VTH.
1. Fill in VTO name, master VTO IP address, set enable status to , see Figure 4-7.
Figure 4-7
2. Fill in VTO name, and extension VTO IP address, select device type, set enable status to
.
The device supports n19 units of extensions, and you can press to page down to
add more extensions.
4.3.3 Successfully Debug
On VTO dial VTO room no. to call VTH. VTH pops up monitoring video and operation buttons,
see Figure 4-8.
To Next Page
Loading...
