Note:
Initial password to enter setting interface, and personal unlock password and
arm/disarm password are all: 123456.
Duress password is the inverse of arm/.disarm password, for example if arm/disarm
password is 123456, then duress password is 654321.
Personal unlock password is used to unlock VTO, as you enter “#+4-digit room
no.+ personal unlock password+#”.
Step 1. Go to Setting>General>Password.
Step 2. Enter old password, new password and confirm new password once. See Figure 5-8.
Figure 5-8
Step 3. Press OK.
5.2.5.4 Other
Go to Setting>General>Other. Press or to adjust monitor time, record time, VTO
message time and VTO call time, inter-resident call time. Press , to enable
inter-resident call, touch tone and etc.
Note:
If message time is set to 0, than you cannot leave a message.
After enable auto snapshot function, when VTH is being called, it auto snapshots
three pictures and save to SD card.
To Next Page
Loading...
Need help?
General
