3. Select System Config>Network, set VTO IP address, subnet mask and
defaul gateway. Click OK, see Figure 3- 2.
Figure 3- 2
3.2 General Config
If you first use VTO, you may need to operate according to the following steps:
Step 1. In Internet Explorer, input IP address of the VTO, enter username and password,
click Login to login WEB.
Note:
Default IP address of VTO is 192.168.1.110. Default username and password is
admin/admin. After first login, please change your password.
Step 2. In WEB interface, select System Config>Video Set, set video format as WVGA
as in Figure 3- 3.
Figure 3- 3
To Next Page
Loading...
