2 | Troubleshooting
Service manual
40
EBLA09~16DA + EDLA09~16DA
Daikin Altherma 3 M
ESIE20-06A – 2021.03
To solve the error code
INFORMATION
It is recommended to perform the checks in the listed order.
1 Clean the outdoor heat exchanger. See "5Maintenance"[4309].
Possible cause: Dirty outdoor heat exchanger.
2 Check that all stop valves of the refrigerant circuit are open. See
"4.2Refrigerant circuit"[4286].
Possible cause: Closed stop valve in the refrigerant circuit.
3 Check the outdoor temperature. See "4.5External factors"[4307].
Possible cause: Outdoor temperature is out of operation range.
4 Check the required space around the outdoor unit heat exchanger. See
"4.5External factors"[4307].
Possible cause: Insufficient air flow or air by‑pass due to required space
specifications not met.
5 Perform a check of the heat exchanger thermistor. See
"3.20Thermistors"[4248].
Possible cause: Faulty heat exchanger thermistor.
6 Perform a check of all expansion valves. See "3.9Expansion valve"[4149].
Possible cause: Faulty expansion valve.
7 Perform a check of the main PCB. See "3.14Main PCB"[4171].
Possible cause: Faulty main PCB.
8 Check if the refrigerant circuit is correctly charged. See "4.2 Refrigerant
circuit"[4286].
Possible cause: Refrigerant overcharge.
9 Check for the presence of non‑condensables and/or humidity in the
refrigerant circuit. See "4.2Refrigerant circuit"[4286].
Possible cause: Non‑condensables and/or humidity in the refrigerant circuit.
10 Check if the refrigerant circuit is clogged. See "4.2Refrigerant circuit"[4286].
Possible cause: Clogged refrigerant circuit.
11 Perform a check of the outdoor unit fan motor. See "3.16 Outdoor unit fan
motor"[4217].
Possible cause: Faulty outdoor unit fan motor.
INFORMATION
If all procedures listed above have been performed and the problem is still present,
contact the helpdesk.
2.3.40 H0-00 – Outdoor unit: Voltage/current sensor problem
Trigger Effect Reset
Compressor voltage (DC)
is out of range before
start‑up.
Unit will stop operating. Manual reset via user
interface.