ESIE11-05 Field Setting from Outdoor Unit
Functional Description 75
7.4 Monitor Mode
The numbers in the "No." column represent the number of times to press the SET (BS2) button.
No. Setting item LED display Data display
H1P H2P H3P H4P H5P H6P H7P
0 Various settings
lhhhhhh
1 C/H unified address
lhhhhhk
2 Low noise/demand address
lhhhhkh
3 Not used
lhhhhkk
4 Not used
lhhhkhh
5 Number of connected hydrobox
PCB’s
lhhhkhk
6 Not used
lhhhkkh
7 Not used
lhhhkkk
8 Number of outdoor units
lhhkhhh
9 Not used
lhhkhhk
10 Not used
lhhkhkh
11 Not used
lhhkhkk
12 Not used
lhhkkhh
13 Not used
lhhkkhk
14 Contents of malfunction (the
latest)
lhhkkkh
Malfunction
code table
Refer to
page 106.
15 Contents of malfunction
(1 cycle before)
lhhkkkk
16 Contents of malfunction
(2 cycle before)
lhkhhhh
20 Contents of retry (the latest)
lhkhkhh
21 Contents of retry (1 cycle before)
lhkhkhk
22 Contents of retry (2 cycle before)
lhkhkkh
25 Not used
lhkkhhk
<Selection of setting item>
<Confirmation on setting contents>
To enter the monitor mode, push the
MODE (BS1) button when in
“Setting mode 1”.
Push the SET (BS2) button and set
the LED display to a setting item.
Push the RETURN (BS3) button to
display different data of set items.
Push the RETURN (BS3) button and
switches to the initial status of
“Monitor mode”.
* Push the MODE (BS1) button and
returns to “Setting mode 1”.
Data such as addresses and number of units is expressed as binary numbers; the two
ways of expressing are as follows:
The No. 1 cool/heat unified address is expressed as a binary
number consisting of the lower 6 digits. (0 - 63)
In
the address is 010110 (binary number), which translates to
16 + 4 + 2 = 22 (base 10 number). In other words, the address is
22.
See the preceding page for a list of data, etc. for No. 0 - 25.
l hlhllh
16 4 1
32 8 2
To Next Page
Loading...
