ESIE11-05 Remote Controller
Functional Description 83
8. Remote Controller
8.1 Temperature Read Out for Remote Control
Wired remote
control
EKRUAHTB
(BRC21A52)
On the remote controller, the actual temperatures can be displayed.
1. Push and hold the ba button for 5 seconds.
The leaving water temperature is displayed (icons l and = and L are blinking).
2. Use the pi and pj buttons to display:
The entering water temperature (icons l and = are blinking and the L icon is
flashing slowly).
The indoor temperature (icons l and = are blinking only when room temperature
control is selected).
The outdoor temperature (icons l and u are blinking).
3. Push the ba button again to leave this mode
.
If no button is pressed, the remote controller
leaves the display mode after 10 seconds.
Schedule timer See Installation Operation Manual.
To Next Page
Loading...
