6.
Press to select the desired time.
7.
Press .
8.
Press to select the desired temperature.
9.
Press .
10
.
Press to complete the setting.
Display
NOTE
• The time can be set between 0:00 and 23:50 in 10-minute intervals.
• To return to the ON/OFF TIMER mode setting, press .
• Proceed to STEP
9
when setting the OFF TIMER.
• The time will be set.
• “ ” and the temperature blink.
• The temperature can be set between 50˚F (10˚C) and 90˚F (32˚C).
COOL or AUTO: The unit operates at 64˚F (18˚C) even if it is set at 50˚F (10˚C) to 63˚F (17˚C).
HEAT or AUTO : The unit operates at 86˚F (30˚C) even if it is set at 87˚F (31˚C) to 90˚F (32˚C).
• To return to the time setting, press .
• The set temperature is only displayed when the mode setting is on.
• The temperature will be set and go to the next reservation setting.
• The temperature is set while in ON TIMER operation, and the time is set while in OFF
TIMER operation.
• The next reservation screen will appear.
• To continue further settings, repeat the procedure from STEP
4
.
• Be sure to direct the remote controller toward the indoor unit and check for a receiving
tone and blinking of the OPERATION lamp.
• “ ” is displayed on the LCD and WEEKLY TIMER operation is activated.
• The TIMER lamp lights orange.
• A reservation made once can be easily copied and the same settings used for another
day of the week. Refer to Copy mode .
Notes on WEEKLY TIMER operation
• Do not forget to set the clock on the remote controller first.
• The day of the week, ON/OFF TIMER mode, time and set temperature (only for ON TIMER mode) can be set with the WEEKLY TIMER.
Other settings for the ON TIMER are based on the settings just before the operation.
• WEEKLY TIMER and ON/OFF TIMER operation cannot be used at the same time. The ON/OFF TIMER operation has priority if it is set while
WEEKLY TIMER is still active. The WEEKLY TIMER will enter the standby state, and “ ” will disappear from the LCD. When the ON/
OFF TIMER is up, the WEEKLY TIMER will automatically become active.
• Only the time and set temperature with the WEEKLY TIMER are sent with the . Set the WEEKLY TIMER only after setting the operation
mode, the airflow rate and the airflow direction ahead of time.
• Turning off the circuit breaker, power failure, and other similar events will render operation of the indoor unit’s internal clock inaccurate. Reset
the clock.
• can be used only for the time and temperature settings. It cannot be used to go back to the reservation number.
To Next Page
Loading...
Need help?
General
