Daikin FTE35KV16 - Remove Display PCB; Remove Control PCB; Removal of Drain Pan Unit; Swing Motor

Si041048 Removal of PCBs
Removal Procedure 17
Step Procedure Points
7. Remove the display PCB.

The display PCB is located
at the back of the signal
receiver unit.
1
The figure shows the
connection of wire
harness for the display
PCB.
2
Unfasten the 3 hooks
and remove the display
PCB.
3
Disconnect the
connector [S27] from
the display PCB.
8. Remove the control PCB.
1
Unfasten the 2 lower
hooks.
Display PCB
(R4366)
(R4367)
Hook
Green
LED 1
Green
LED 3
Yellow
LED 2
(R4368)
[S27]
Control
PCB
Hook
Hook
(R4369)