Daikin FTX-N/U - Page 199

FTX-N/U, FVXS-N, FDMQ-R Series EDUS091558E
197
C: 3P379751-4C
10
Read Before Operation
Preparation Before Operation
To insert the batteries
1. Remove the back cover by sliding and then
slightly lifting it�
2. Insert 2 dry batteries AAA�LR03 (alkaline)�
3. Replace the back cover�
To x the remote controller holder to a wall
1. Choose a place where the signals reach the unit�
2. Attach the holder to a wall, a pillar, or similar
location with the screws supplied with the holder�
3. Hang the remote controller on the remote
controller holder�
Fahrenheit/Celsius display switch
Press and (TIMER button)
simultaneously for about 5 seconds�
• The temperature will be displayed in Celsius when it is presently displayed in
Fahrenheit, and vice versa.
• The switch operation is only possible when the temperature is being displayed.
Turn on the circuit breaker
• After the power is turned on, the ap of the indoor unit opens and closes once to set the
reference position.
Position and
correctly!
2
3
1
Remote
controller holder
Remote controller
Screws
NOTE
Notes on batteries
• When replacing the batteries, use batteries of the same type, and replace bothold batteries together.
• The batteries will last for about 1 year. However, if the remote controller display begins to fade and the possible transmission range becomes
shorter within a year, replace both batteries with new, size AAA.LR03 (alkaline) batteries.
• The batteries supplied with the remote controller are for initial operation. The batteries may run out in less than 1 year.
Note on remote controller
• Do not drop the remote controller. Do not get it wet.
Fahrenheit/Celsius display change function of remote controller
• The set temperature may increase when the display is changed to Celsius from Fahrenheit, because a fraction of 0.5°C is rounded up.
• Example: A set temperature of 65°F (equivalent to 18.5°C) will be converted into 19°C.
When the display is changed to Fahrenheit again, the set temperature will be converted into 66°F (equivalent to 19°C) instead of the original
set temperature (65°F) but a set temperature of 66°F (equivalent to 19°C) will be converted into 19°C with no temperature change.
• A reception sound will go off for the transmission of set temperature to the indoor unit at the time of setting the Fahrenheit/Celsius display change function.
01_EN_3P379751-4C.indd 10 11/6/2015 16:14:35