10
Daintree
™
Controls
|
WHS20/WHR1
User Manual
|
V1.0
Daintree Networked Profiles
When the WHS20 sensor is operating in Daintree Networked mode, it connects to a Daintree™ Wireless Area
Controller (WAC60) and is wirelessly controlled by the Daintree lighting control software. In this mode, the
Sensor operates as part of a wireless controlled network and settings must be configured using the Daintree
control software.
The WHR1 can be used to modify the following settings of a device’s Daintree Networked profile prior to the
device joining a network:
• Power-On Configuration
• iBeacon operation
For the WHS20 sensor to operate in Daintree Networked mode, you must send a Daintree Networked profile
to the sensor from the WHR1 remote.
Note: iBeacon operation is only permitted on devices running a Daintree Networked profile.
To Next Page
Loading...