Daintree GE current WHS20 User Manual

13
Daintree
™
Controls
|
WHS20/WHR1 User Manual
|
V1.0
2 3
4 6
Send Profile to a WHS20 Sensor
After creating a profile on the WHR1 or saving an existing profile from a WHS20 sensor, you can send the profile
to another WHS20 Sensor to apply the profile’s configurations to the device.
1. Select the desired profile to open the profile details page.
2. Click DOWN button until “Send” is highlighted.
3. Click RIGHT button to choose the “Send” option.
4. Point the remote at the WHS20 Sensor. Click CENTER button to send the profile.
5. If multiple devices were detected, use UP/DOWN buttons to highlight the desired device and then press
RIGHT button to select.
6. The message shows that the profile was sent successfully.
1
4
2
5
3
6

Daintree GE current WHS20 Specifications

General

Brand	Daintree
Model	GE current WHS20
Category	Remote Control
Language	English