Daintree GE current WHS20 - Adjusting Occupancy Sensor Settings;Example Operations

15
Daintree
™
Controls
|
WHS20/WHR1 User Manual
|
V1.0
IDLEIDLE
IDLE
Rise
Time
Fall
Time
Occupied
Timeout
Occupied
Timeout
VACANT
OCC
OCC
PWR ON
PWR ON
Idle Timeout
Power On Level
Power On Timeout
Occupied Level
Idle Level
Vacant Level
Time
Time
Time
OC
CO
CC
Output
Level
Power On Level
Occupied Level
Idle Level
Vacant Level
Output
Level
Note:
Occupancy control can also interact
with Ambient Light control
Adjusting Occupancy Sensor Settings
Example Operation
The following is a simple example of the operation of the WHS20 sensor while the Occupancy Detection
feature is enabled and configured. Please review the WHS20 Application Note for more details on the
Occupancy Detection operation.
1. Occupancy is detected
a. Light output goes to Occupied Output setting (Example: Occupied Output = 100%)
b. Occupied Time clock starts counting down (Example: Occupied Time = 15 minutes)
2. Occupied Time clock runs out
a. Light output goes to Idle Output setting (Example: Idle Output = 50%)
b. Idle Time clock starts counting down (Example: Idle Time = 20 minutes)
3. Idle Time clock runs out
a. Light output goes to Vacant Output setting (Example: Vacant Output = 0%, Off)
b. LED fixture stays at this output level until occupancy is detected
4. Note: If at any time occupancy is detected, the LED fixture will go to the state listed in Step 1
(and this process will be restarted)
1
4
2
3