Daintree
™
Controls
|
WHS20/WHR1
User Manual
|
V1.0
Additional Information
Note: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
The communication between the WHR1 remote and the WHS20 sensor uses IR communication. Please be
mindful of other sources of IR (such as a cell phone) while using this device.
This device complies with Industry Canada’s license-exempt RSS standards. Operation is subject to the following
two conditions:
This device may not cause interference; and
This device must accept any interference, including interference that may cause undesired operation of the device.
Le present appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de
licence. L’exploitation est autorisée aux deux conditions suivantes:
l’appareil ne doit pas produire de brouillage, et l’utilisateur de l’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est susceptible d’en compromettre le fonctionnement.
Warning: Any changes or modifications not approved by GE Current, a Daintree company could void the user’s
authority to operate this equipment.
© 2020 Current Lighting Solutions, LLC. All rights reserved. GE and the GE monogram are
trademarks of the General Electric Company and are used under license. iBeacon is a trademark
of Apple Inc. Information provided is subject to change without notice. All values are design or
typical values when measured under laboratory conditions.
DT023 (Rev 10/01/20)
www.gecurrent.com
T 1-888-694-3533
For more information contact your Current rep or go to https://products.gecurrent.com
To Previous Page
Loading...
Need help?
General