14
Available Settings
To enable occupancy-based lighting controls, use the Occupancy Detection feature as part of a
Daintree One profile.
For Occupancy Detection configuration, the following Light Output Level Settings can be adjusted:
• Occupied Output – The light output level that will be set when occupancy is detected
(during the Occupied Time)
• Idle Output – The light output level that will be set after the occupancy event detected times out
(during the Idle Time)
• Vacant Output – The light output level that will be set after the idle time runs out (during the Vacant Time)
The following Timing Settings can be adjusted:
• Occupied Time – The time period after an occupancy event is detected where the LED fixture will be set at
the Occupied Output. After this time period elapses, the LED fixture will be set to the Idle Output setting.
• Idle Time – The time period that starts after the Occupied Time runs out. During this time period the LED
fixture will be set to the Idle Output. After this time period elapses, the LED fixture will be set to the Vacant
Output setting.
Daintree
®
Controls
Occupancy Detection Conguration Details
100%
50%
Occupied
Output
Occupied Time Idle Time
Idle
Output
Vacant
Output
OFF
To Next Page
Loading...
Need help?
General