Spyder 3 CL User's Manual PRELIMINARY 37
DALSA 03-032-20008-03
6 Troubleshooting
6.1 Troubleshooting
The information in this chapter can help you solve problems that may occur during the
setup of your camera. Remember that the camera is part of the entire acquisition system.
You may have to troubleshoot any or all of the following:
• power supplies • cabling
• software • host computer
• light sources • optics
• operating environment • encoder
LED
When the camera is first powered up, the LED will glow on the back of the camera. Refer
to section 2.3 for information on the LED.
Connections
The first step in troubleshooting is to verify that your camera has all the correct
connections.
Cable Length/Type
Use the scb command to select the correct cable parameter for the cable length.
Equipment Requirements
Ensure that you are using compatible equipment.
Power Supply Voltages
Check for the presence of all voltages at the camera power connector. Verify that all
grounds are connected. Verify input voltage with the camera’s ‘vv’ serial command.
To Next Page
Loading...
Need help?
General