86 PRELIMINARY Spyder 3 CL User's Manual
03-032-20008-03 DALSA
Syntax Parameters
Description
get srm
Returns the readout mode:
0 = Auto.
1 = Dark current clear.
2 = Immediate readout. Does not clear dark current.
get ssb
t
Returns the current background subtract value.
t = Tap value. 0 for all taps or 1 to 2 for individual tap
selection depending on camera model.
get ssf
Returns the current line/frame rate in Hz.
get ssg
t
Returns the current digital gain setting.
t = tap selection, either 1 to 2 depending on camera
model, or
0 for all taps
get ssm
Returns the current sensitivity mode where:
0 = Low sensitivity mode
1 = High sensitivity mode
2 = Tall pixel mode
get sut
Returns the current upper threshold value.
get svm
Returns the current video mode.
0: Normal video mode
1: Test pattern
2: Test pattern
get ugr
t
Returns the gain reference value.
t = tap selection, either 1 to 2 depending on camera
model, or
0 for all taps
get vt
Returns the camera’s internal chip temperature in degrees
Celsius.
get vv
Returns the camera’s supply voltage.
get wfc
Returns whether FPN coefficients have been saved.
0 = No FPN coefficients saved
1 = Pixel coefficients have been saved
get wpc
Returns whether PRNU coefficients have been saved.
0 = No PRNU coefficients saved
1 = Pixel coefficients have been saved
get wus
Returns whether user settings have been saved.
0 = No user settings saved
1 = User settings have been saved
7.17 ASCII Commands: Reference
The following table lists all of the camera’s available ASCII commands. Refer to
Appendix A for detailed information on using these ASCII commands.
To Next Page
Loading...