72 PRELIMINARY Spyder 3 CL User's Manual
03-032-20008-03 DALSA
Notes: Coefficients must be created first with the cil command.
Setting saved with the
wfs and wus commands.
Example:
Write Input LUT
Purpose: Saves current values of input LUT that are in FPGA SDRAM to
Flash memory or a PC file.
Syntax:
wil
Syntax Elements:
Example:
wil
Notes: 0 = Factory set
1
to 4 = User sets
Input LUT is loaded by LIL, and automatically at power-up.
LUT use is enabled or disabled with the EIL command.
Set 0 can only be written from factory mode.
Load Input LUT
Purpose: Load previously stored LUT from non-volatile memory to FPGA
SDRAM.
Syntax:
lil
Syntax Elements:
Example:
lil
Notes: 0 = Factory set
1 to 4 = User sets
LUTs are only loaded from non-volatile memory on: power-up,
LIL.
Related Commands:
wil
To Next Page
Loading...