d&b audiotechnik 10D - 5 Overview; Connections; Controls and Indicators - User Interface

5.1. Connections
[1] Mains connector socket.
Refer to Þ Chapter 6.2.1. "Mains
connection" on page 13.
[2] Audio INPUT (analog/digital) and
LINK connectors.
Refer to Þ Chapter 6.2.2. "Audio
INPUT and LINK connectors"
on page 14.
[3] Output connectors.
Refer to Þ Chapter 6.2.3. "Output
connectors" on page 15.
[4] ETHERNET.
Refer to Þ Chapter 6.2.4.
"ETHERNET (Dual Ethernet port)"
on page 16.
[5] CAN (CAN-Bus).
Refer to Þ Chapter 6.2.5. "CAN
(CAN-Bus)" on page 17.
[6] GPIO connector.
Refer to Þ Chapter 6.2.6. "GPIOs
(Hardware description)"
on page 18
[7] FAULT connector.
Refer to Þ Chapter 6.2.7. "FAULT
contact" on page 18
5.2. Controls and indicators - User interface
[8]
Mains power switch.
Refer to Þ Chapter 6.3. "Controls
and indicators" on page 19,
following Þ Chapter 6.3.1. "Mains
power switch" on page 19
[9] RESET
Refer to Þ Chapter 6.3.2. "RESET
(System reset)" on page 19
[10] Status LEDs
Refer to Þ Chapter 6.3.3. "Status
indicators (LEDs)" on page 20
5. Overview
d&b 10D/30D Manual 1.10 en 11